Specifications

DS300f G2 Series User Manual
93
makInG DISk array SettInGS
To make disk array settings:
1. Click the Storage tab.
2. Click the Disk Array icon.
The list of disk arrays appears.
3. Clickthediskarrayyouwant,thenclicktheSettings button.
4. Make settings changes as required:
•
Enter,changeordeletethealiasintheAliaseld
Maximumof32characters;letters,numbers,spacebetweencharacters,andunderline.
• MediaPatrol–Checktoenable,unchecktodisableonthisarray.
• PDM–Checktoenable,unchecktodisableonthisarray.
• PowerManagement–Checktoenable,unchecktodisableonthisarray.
5. Click the Save button.
Notes
You can also enable or disable Media Patrol for the entire RAID system. See Making Media
Patrol Settings.
HDD Power Saving must be enabled on the RAID controller for the Power Management
settings to be effective. See Making Controller Settings.
Power Management functions are limited to the features your HDDs actually support.
DeletInG a DISk array
Caution
If you delete a disk array, you also delete any logical drives that belong to it, along
with the data in those logical drives. Back up any important data before deleting a
disk array.
This action requires
Administrator or SuperUser privileges.
To delete a disk array:
1. Click the Storage tab.
2. Click the Disk Array icon.
3. Clickthediskarrayyouwant,thenclicktheDelete button.
4. In the Conrmationbox,typetheword“conrm”intheeldprovidedandclicktheConrm button.
locatInG a DISk array
ThisfeaturecausesthedrivecarrierLEDstoashforoneminutetoassistyouinlocatingthephysicaldrives
that make up this disk array.
To locate a disk array:
1. Click the Storage tab.
2. Click the Disk Array icon.
The list of disk arrays appears.
3. Clickthediskarrayyouwant,thenclicktheLocate button.
ThedrivecarrierstatusLEDsforthearrayashforoneminute.
Figure 4 - 6: Drive carrier status LED
DriveStatusLED