Specifications

DS300f G2 Series User Manual
81
MAking ssh settings
To change SSH service settings:
1. Click the Administration tab.
2. Click the Services icon.
3. Click the SSH service and click the Settings button.
4. Make settings changes as required:
•
Chooseastartuptype,
Automatic–(default)Startsandrunswiththesubsystem.
Manual–Youstarttheservicewhenyouneedit.
• Portnumber-Defaultis22.
• MaxNumberofConcurrentConnections–Defaultis4.
Maximumnumberis4.
• SessionTimeOut-Defaultis24minutes.
5. Click the Save button.
6. Click the Conrm button.
SnmP ServIce
Simple Network Management Protocol (SNMP) service enables the SNMP browser to obtain information from
the RAID subsystem. The Trap Sink is where SNMP events are sent and can be viewed.
stoPPing snMP service
To stop the SNMP service:
1. Click the Administration tab.
2. Click the Services icon.
3. Click SNMP service and click the Stop button.
4. Click the Conrm button.
To start the SNMP service after stopping it:
1. Click the Administration tab.
2. Click the Services icon.
3. Click SNMP service and click the Start button.
restArting snMP service
To restart the SNMP service:
1. Click the Administration tab.
2. Click the Services icon.
3. Click the SNMP service and click the Restart button.
MAking snMP settings
To change SNMP service settings:
1. Click the Administration tab.
2. Click the Services icon.
3. Click the SNMP service and click the Settings button.
4. Make settings changes as required:
•
Chooseastartuptype,
Automatic–(default)Startsandrunswiththesubsystem.
Manual–Youstarttheservicewhenyouneedit.
• PortNumber–Defaultis161.
• SystemName–Nodefault.
• SystemLocation–DefaultisUSA.
• SystemContact–Defaultis[e-mail].
• ReadCommunity–Defaultispublic.
• WriteCommunity–Defaultisprivate.Nochangesarepossible.
5. Click the Save button.
6. Click the Conrm button.
Adding An snMP trAP sink
To add a trap sink:
1. Click the Administration tab.
2. Click the Services icon.
3. Click SNMP service and click the Settings button.
4. EnteratrapsinkserverIPaddressintheeldprovided.
5. Chooseatraplter(eventseveritylevel).
See the table on the next page.
6. Click the Add button.
7. Click the Conrm button.