Specifications

DS300f G2 Series User Manual
68
vIewInG uPS InformatIon
ToviewinformationaboutaspecicUPS unit:
1. Click the Device tab.
2. Click the UPS icon.
3. Mouse-over UPS and click the View button.
UPS information includes:
•
UPSID
• ModelName
• SerialNumber
• FirmwareVersion
• ManufactureDate
• VoltageRating–OutputvoltageoftheUPS.
• BatteryCapacity–Backupcapacityexpressedasapercentage.
• RemainingBackupTime–NumberofminutestheUPSisexpected
topoweryoursystemintheeventofapowerfailure.
• LoadingRatio–ActualoutputofUPSasapercentageoftheratedoutput.SeetheNotebelow.
• Temperature–ReportedtemperatureoftheUPSunit.
Note
The maximum recommended Loading Ratio varies among models of UPS units. The general range
is 60% to 80%. If the reported Loading Ratio exceeds the recommended value for your UPS unit:
Have fewer subsystems or peripherals connected to this UPS unit.
AddmoreUPSunits,oruseahigher-capacityUPSunit,toprotectyourRAIDsystems.
ManaGInG network ConneCtIons
Network Connections Management includes the following functions:
• "Making Virtual Management Port Settings" on page 68
• "Making Maintenance Mode Settings" on page 69
makInG vIrtual manaGement Port SettInGS
TheASUSDS300fG2subsystemhasavirtualmanagementport,enablingyoutologintoaASUSDS300fG2
with dual controllers using one IP address.
Beforeyouchangesettings,pleasesee“AboutIPAddresses”onpage36.
You initially made these settings during subsystem setup. You can change them later as required.
Caution
Changing virtual management port settings can interrupt your ASUS Storage Man-
agement connection and require you to log in again.
To make virtual management port settings:
1. Click the Administration tab.
2. Click the Network Management icon.
3. Click the Virtual Management Port tab.
4. Click the protocol family whose settings you want to change and click the Conguration button.
5. Make the following settings are needed:
•
ChecktheEnableboxtoenablethisprotocolfamily.
• ChecktheEnable DHCP boxtoenableaDHCPservertomakeyour
networksettings.DHCPiscurrentlysupportedinIPv4only.
• Formanualnetworksettings,typetheRAIDsubsystem’sIPaddress,subnetmask,
gatewayIPaddress,andDNSserverIPaddressintotheeldsprovided.
6. Click the Submit button.