Specifications

DS300f G2 Series User Manual
212
seriAl connection
To clear maintenance mode using a serial connection:
1. Changeyourterminalemulationprogramsettingstomatchthefollowingspecications:
• Bitspersecond:115200
• Databits:8
• Parity:None
• Stopbits:1
• Flowcontrol:none
2. StartyourPC’sterminalVT100orANSIemulationprogram.
3. Press EnteroncetolaunchtheCLI.
Theloginscreenappears.
ThefollowingstepsshowthedefaultAdministratorusernameandpassword.Useyourownusername
andpasswordifyouhavechangedthese.
4. AttheLoginprompt,typeadministrator and press Enter.
5. AtthePasswordprompt,typepassword and press Enter.
TheCLIscreenappears.
ThepromptshoulddisplayMAINTENANCEMODE@cli>.Ifthepromptdisplaysyourloginname,suchas
administrator@cli>,logintotheothercontroller.
6. AttheMAINTENANCEMODE@cli>prompt,typemaintenance -a exit and press Enter.
Thecontrollerreboots.Theloginscreenagainappears.
7. ClosetheSerialconnection.
telnet connection
ThisprocedurerequiresyoutoknowtheIPaddressofthecontroller.
To clear maintenance mode using a Telnet connection:
1. Gotothecommandlineprompt(Windows)orclicktheterminalicon(Linux),thenrun:
telnet 10.0.0.1 2300
TheIPaddressaboveisonlyanexample.2300istheTelnetportforASUSDS300fG2.
Theloginscreenappears.
ThefollowingstepsshowthedefaultAdministratorusernameandpassword.Useyourownusername
andpasswordifyouhavechangedthese.
2. AttheLoginprompt,typeadministrator and press Enter.
3. AtthePasswordprompt,typepassword and press Enter.
TheCLIscreenappears.
ThepromptshoulddisplayMAINTENANCEMODE@cli>.Ifthepromptdisplaysyourloginname,suchas
administrator@cli>,logintotheothercontroller.
4. AttheMAINTENANCEMODE@cli>prompt,typemaintenance -a exit and press Enter.
Thecontrollerreboots.TheTelnetsessionends.
unSaveD Data In the controller cache
The dirty cache LED (marked with the icon) informs you that there is data in the cache that has not been
savedtonon-volatilememory.Suchdataissometimescalled“dirty,”nottosuggestitiscorruptedinsomeway
butbecauseithasnotbeensavedtoaphysicaldrive.
Caution
If there is unsaved data in the controller’s cache, the dirty cache LED shines amber.
During this time, do NOT power down the ASUS DS300f G2. Wait until the LED goes
dark.