Specifications

DS300f G2 Series User Manual
170
StartInG uP the aSuS DS300f G2 – SerIal connectIon
Important
IfyouhaveaJBODExpansion,alwayspowerontheJBODsubsystemsrst.Then
power on the RAID subsystem.
To start the RAID subsystem:
1. Manually turn on the system by pressing the power button on the front left side
2. Wait about two minutes
3. Establish a serial connection to the ASUS DS300f G2.
See Making a Serial Connection.
WhentheLogin:promptappears,thestartupisnished.
4. Type menu and press Enter to open the CLU.
restartInG the subsysteM
There are two methods for restarting the subsystem. Choose one of the following procedures:
• "Restarting ASUS DS300f G2 – Telnet Connection" on page 170
• "Restarting ASUS DS300f G2 – SSH Connection" on page 171
• "Restarting ASUS DS300f G2 – Serial Connection" on page 171
Note
If you have a JBOD Expansion, you are not required to restart the JBOD subsystems when you restart
the RAID subsystem.
•
reStartInG aSuS DS300f G2 – telnet connectIon
To restart the RAID subsystem:
1. From the Main Menu, highlight Additional Info and Management and press Enter.
2. Highlight Shutdown or Restart and press Enter.
3. Highlight Option and press the spacebar to display Restart.
4. Highlight Submit and press Enter.
A warning message appears.
5. Press Y to continue.
The screen goes blank.
6. Wait about two minutes.
7. Re-establish your Telnet connection to the ASUS DS300f G2 CLU.
See Making a Telnet Connection.
If you cannot re-establish a connection, wait 30 seconds and try again.