Specifications

DS300f G2 Series User Manual
166
6. Typetherecipient’sIPaddressintotheeldprovided.
7. Highlight Message Event Severity Filter and press the spacebar to change severity levels.
The selected level and all higher severity levels of severity are reported.
See the Table below.
8. Press Control-A to save your settings.
Event Severity Levels
Level Description
Fatal
Non-recoverableerrororfailurehasoccurred.
Critical Actionisneedednowandtheimplicationsoftheconditionareserious.
Major Actionisneedednow.
Minor Actionisneededbuttheconditionisnotaseriousatthistime.
Warning Usercandecidewhetherornotactionisrequired.
Information Informationonly,noactionisrequired.
deleting netsend reciPients
To delete a Netsend recipient:
1. From the Main Menu, highlight Additional Info and Management and press Enter.
2. Highlight Software Management and press Enter.
3. Highlight Netsend and press Enter.
4. Highlight Message Recipients and press Enter.
5. Highlight the recipient you want to delete and press the spacebar to mark it.
The mark is an asterisk (*) to the left of the listing
6. Highlight Delete Marked Entries and press Enter.
flaShInG throuGh tftP
Usethisfunctiontoash(update)thermwareontheASUSDS300fG2.See"Updating with the CLU" on page
<OV>
vIewInG flash IMaGe InforMatIon (Clu)
Flash image information refers to the package of rmware components running on your ASUS DS300f G2
controller or controllers.
Toviewashimageinformation:
1. From the Main Menu, highlight Additional Info and Management, and press Enter.
2. Highlight Flash Image Version Info and press Enter.
Theashimageinformationdisplaysonthescreen:
• EnclosureNumber–1(one)istheHeadUnit.Othernumbersarecascadedorexpandedsubsystems
• RunningImageInfo–Firmwarecurrentlyrunningonthecontrollers
• FlashedImageInfo–Firmwareashedtomemory
• ImageType–Aspeciccomponent
• ControllerID–1or2
• Versionnumber
• Builddate
• Flash(installation)date
If the Running and Flashed Images do not match, the ASUS DS300f G2 has not restarted since the
rmwarewaslastupdated.RestarttheASUSDS300fG2toruntheFlashedrmwarepackage.See
"Restarting a Subsystem" on page <?>
Note that all of these components are upgraded together in a package. See "Updating with the CLU" on
page <OV>.