Specifications

DS300f G2 Series User Manual
165
Adding A trAP sink
To add a trap sink:
1. From the Main Menu, highlight Additional Info and Management and press Enter.
2. Highlight Software Management and press Enter.
3. Highlight SNMP and press Enter.
4. Highlight Trap Sinks and press Enter.
5. Highlight Create New Trap Sink and press Enter
6. Highlight Trap Sink IP address and press the backspace key to erase the current value, then type the new
IPaddressinthiseld.
7. Highlight Trap Filter and press the spacebar to toggle through the severity levels.
See the Table below.
8. Press Control-A to save the Trap Sink.
Event Severity Levels
Level Description
Fatal
Non-recoverableerrororfailurehasoccurred.
Critical Actionisneedednowandtheimplicationsoftheconditionareserious.
Major Actionisneedednow.
Minor Actionisneededbuttheconditionisnotaseriousatthistime.
Warning Usercandecidewhetherornotactionisrequired.
Information Informationonly,noactionisrequired.
deleting A trAP sink
To delete a trap sink:
1. From the Main Menu, highlight Additional Info and Management and press Enter.
2. Highlight Software Management and press Enter.
3. Highlight SNMP and press Enter.
4. Highlight Trap Sinks and press Enter.
5. Highlight the trap sink you want to delete and press the spacebar to mark it.
The mark is an asterisk (*) to the left of the listing.
6. Highlight Delete Marked Entries and press Enter.
makInG netSenD SettInGS (clu)
By default, Netsend service is set to Manual and its normal status is Stopped.
To make Netsend service settings:
1. From the Main Menu, highlight Additional Info and Management and press Enter.
2. Highlight Software Management and press Enter.
3. Highlight Netsend and press Enter.
4. Highlight Startup Type and press the spacebar to toggle between Automatic and Manual.
5. Press Control-A to save your settings.
To start, stop or restart the Netsend service, highlight Start, Stop, or Restart and press Enter.
manaGInG netSenD recIPIentS (clu)
ASUS DS300f G2’s Netsend service sends ASUS DS300f G2 subsystem events in the form of text messages to
your Host PC and other networked PCs.
netsend requireMents
In order to use Netsend:
• NetSend must be running the ASUS DS300f G2
• You must provide the IP address for each recipient PC
• The Messenger service must be running on each recipient PC
If your Netsend and Messenger service settings are correct but the recipient PC does not receive event messages,
check the recipient PC’s Firewall settings. Refer to your OS documentation for more information.
Adding netsend reciPients
To add a Netsend recipient:
1. From the Main Menu, highlight Additional Info and Management and press Enter.
2. Highlight Software Management and press Enter.
3. Highlight Netsend and press Enter.
4. Highlight Message Recipients and press Enter.
5. Highlight Create New Message Recipient and press Enter.