Specifications

DS300f G2 Series User Manual
161
5. Highlight Privilege and press the space bar to toggle though the options.
See the Table on the next page.
6. Press Control-A to save the user.
User Privileges
Level Meaning
View
Allowstheusertoseeallstatusandsettingsbutnottomakeanychanges
Maintenance
AllowstheusertoperformmaintenancetasksincludingRebuilding,PDM,Media
Patrol,andRedundancyCheck
Power
Allowstheusertocreate(butnotdelete)diskarraysandlogicaldrives,change
RAIDlevels,changestripesize;changesettingsofcomponentssuchasdisk
arrays,logicaldrives,physicaldrives,andthecontroller
Super
Allowstheuserfullaccesstoallfunctionsincludingcreateanddeleteusersand
changingthesettingsofotherusers,anddeletediskarraysandlogicaldrives.
Thedefault“administrator”accountisaSuper User
chanGInG another uSer’S SettInGS (clu)
The Administrator or a Super User can change other users’ settings.
To change user settings:
1. From the Main Menu, highlight Additional Info and Management and press Enter.
2. Highlight User Management and press Enter.
3. Highlight the User whose settings you want to change and press Enter.
4. Highlight Privilege and press the space bar to toggle though the options.
See the Table above.
5. Highlight Status and press the space bar to toggle between Enabled and Disabled.
6. Highlight the items you want and press the backspace key to erase the current value, then type the new
value:
•
User name
• Email address
7. Press Control-A to save the settings.
Important
If a user is logged-in when his account is disabled, the user is immediately logged-out.
chanGInG your own uSer SettInGS (clu)
Each user can change their display name and email address.
To change your user settings:
1. From the Main Menu, highlight Additional Info and Management and press Enter.
2. Highlight User Management and press Enter.
3. Highlight your name and press Enter.
4. Highlight the items you want and press the backspace key to erase the current value, then type the new
value:
•
User name
• Email address
5. Press Control-A to save the settings.
chanGInG another uSer’S PaSSworD (clu)
The Administrator or a Super User can change other users’ passwords.
To change a password:
1. From the Main Menu, highlight Additional Info and Management and press Enter.
2. Highlight User Management and press Enter.
3. Highlight the User whose password you want to change and press Enter.
4. Highlight Change Password... and press Enter.
5. Highlight New Password and type a new password.
Maximum 31 characters. Use letters, numbers, and underscore.
6. Highlight Retype Password and type the new password again to verify.
7. Press Control-A to save the new password.
Note
To reset the Administrator’s password to the factory default, see "Restoring Factory Defaults
(CLU)" on page 167.