Specifications

DS300f G2 Series User Manual
113
vIewInG IScSI Port InformatIon
To view information about a port:
1. Click the Device tab.
2. Click the iSCSI Management icon.
3. Click the Port tab.
4. Clicktheportyouwant,thenclicktheView button.
Port information includes:
• ControllerID–IDoftheRAIDcontrollerwheretheportislocated
• Status–Enabledordisabled*
• JumboFrames–Enabledordisabled*
• LinkStatus–Upordown,activeorinactive
• MACAddress–MACaddressofthetargetport
• MaxSupportedSpeed–Maximumspeedsupported(1Gb/s)
• CurrentSpeed–Currentoractualspeedofthetargetport
• RelativePortals–Theportalscorrespondingtothistargetport
Items marked with an asterisk (*) are adjustable under "Making iSCSI Port Settings"
makInG IScSI Port SettInGS
To make iSCSI port settings:
1. Click the Device tab.
2. Click the iSCSI Management icon.
3. Click the Port tab.
4. Clicktheportyouwant,thenclicktheSettings button.
5. Make settings changes as required:
•
JumboFrames–Checktoenablejumboframesupportonthisport.Unchecktodisable.
6. Click the Submit button.
vIewInG a lISt of IScSI trunkS
A trunk is the aggregation of two or more iSCSI ports to increase bandwidth.
To view a list of trunks:
1. Click the Device tab.
2. Click the iSCSI Management icon.
3. Click the Trunk tab.
Trunk information includes:
•
TrunkID–IDnumberofthetrunk
• ControllerID–IDoftheRAIDcontroller,1or2
• MasterPort–IDofthemasterport
• SlavePorts–IDsoftheslaveports
• FailedPorts–IDsofanyportsthatarenotworking
• State–Optimal,Sub-Optimal,orFailed
Failed ports result in sub-optimal and failed trunks.
aDDInG IScSI trunkS
Ports must be enabledtoaddthemtoatrunk.ASUSDS300fG2supportsamaximumofeighttrunks.
YoucannotuseaniSCSIportthathasportalsconguredtoit.See"Viewing a List of iSCSI Portals" and "Deleting
iSCSI Portals."
To add an iSCSI trunk:
1. Click the Device tab.
2. Click the iSCSI Management icon.
3. Click the Trunk tab.
4. Click the Create Trunk button.
5. Make your choices as required:
•
ControllerID–IDoftheRAIDcontroller,1or2
• MasterPortnumber–IDofthemasterport
• SlavePortnumber–IDstheslaveports