Users Manual Part 2

快速使用指南
6
繁體中文
繁體中文
Getting started
Installing the batteries to your gaming mouse:
CAUTION!
• Ensurethebatteriesareinstalledinthecorrectorientation,refertothedirection
indicatedinthebatterycompartment.
• Thebundledbatteriesarenon-rechargeable.
• DONOTmixnewbatterieswitholdbatteries.
IMPORTANT
• Onlyuseakalinebatterieswheninstallingbatteriestoyourgamingmouse.
• Werecommendyouremovethebatteriesfromyourgamingmouseifthegamingmouse
willnotbeinuseforaprolongedperiodoftime.
1. Liftthetopcoverfromtherearofyourgamingmousetoremovethetopcover.
2. Installthetwo(2)bundledAAbatteriesintothebatterycompartmentofyourROGSTRIXCARRY
GamingMouse.
3. Replacethecoverontopofyourgamingmouse,thenpushdownontheleftandrightmouse
buttonstosecurethetopcover.
RefertothetablebelowforthebatterystatusofyourROGSTRIXCARRYGamingMouse.
LED color Duration Description
Green* Lightsupfor5seconds BatteryPower75%-100%
Red Blinkstwiceevery0.5seconds BatteryPowerunder25%
* The LED indicator will only light green when you set the connection mode to RF 2.4G Wireless mode,
or when setting to Bluetooth mode after the gaming mouse has already been paired.
To connect your ROG STRIX CARRY Gaming Mouse:
Using the RF 2.4G Wireless mode
1. ConnectthebundledUSBdongletoyourcomputer’sUSBport.
2. SettheconnectionswitchtotheRF2.4GWirelessmode.
3. Yourgamingmouseshouldautomaticallystartpairing.Onceyourgamingmousehasbeen
successfullypaired,theLEDindicatoronyourgamingmousewilllightupgreenfor5seconds.
Pairing your gaming mouse via Bluetooth
1. SettheconnectionswitchtotheBluetoothconnectionmode.
2. SetupyourPCtobeginpairing.ClickonStart > Control Panel > Devices and Printers,then
clickonAdd a deviceandselectROG STRIX CARRYtobeginpairing.
NOTE:ThestepstosetupyourPCarethesameforbothWindows
®
7andWindows
®
10.
3. PressandholdtheLeft button,Right button,andDPI buttonforapproximately3secondsto
startpairing.OncetheLEDindicatorstartstoblinkblueyoumayreleasethebuttons.