Specifications

16 CUW-AM User’s Manual
13) CPU and Power Supply Fan Connectors (3-pin CPU_FAN, PS_FAN)
Orientate the fan so that the heat sink fins allow airflow to go across the onboard
heat sink(s) instead of the expansion slots. Depending on the fan manufacturer,
the wiring and plug may be different. The red wire should be positive, while the
black should be ground. Connect the fan’s plug to the board taking into consid-
eration the polarity of the connector.
NOTE: The “Rotation” signal cannot be monitored on this motherboard.
WARNING! The CPU and/or motherboard will overheat if there is no airflow
across the CPU and onboard heatsinks. Damage may occur to the motherboard
and/or the CPU fan if these pins are incorrectly used. These are not jumpers,
do not place jumper caps over these pins.
0 1
CUW-AM
CUW-AM 12-Volt Cooling Fan Power
PS_FAN
SYS_FAN
CPU_FAN
GND
Rotation
+12V
GND
Rotation
+12V
2. HARDWARE SETUP
Connectors
2. H/W SETUP
14) LCD-TV Headers (Two 20-1 pin LCDTV)
These headers require an optional LCD module for LCD output or a TV-out
module for TV output.
0 1
CUW-AM
CUW-AM LCD-TV Headers
1
LCDTV