User's Manual

NO DISASSEMBLY
The warranty does not apply to the products that
have been disassembled by users
DO NOT throw the Chromebit in municipal
waste. This product has been designed to
enable proper reuse of parts and recycling.
This symbol of the crossed out wheeled bin
indicates that the product (electrical, electronic
equipment, and mercury-containing button
cell battery) should not be placed in municipal
waste. Check local technical support services for
product recycling.
Regulatory notices
REACH
Complying with the REACH (Registration, Evaluation,
Authorization, and Restriction of Chemicals) regulatory
framework, we publish the chemical substances in our
products at ASUS REACH website at http://csr.asus.com/
english/REACH.htm
ASUS Recycling/Takeback Services
ASUS recycling and takeback programs come from our
commitment to the highest standards for protecting our
environment. We believe in providing solutions for you
to be able to responsibly recycle our products, batteries,
other components, as well as the packaging materials.
Please go to http://csr.asus.com/english/Takeback.htm
for the detailed recycling information in different regions.
Coating Notice
IMPORTANT! To provide electrical insulation and
maintain electrical safety, a coating is applied to
insulate the device except on the areas where the I/
O ports are located.
Federal Communications Commission
Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
• This device may not cause harmful interference,
and
• This device must accept any interference received
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with manufacturer’s
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected.
RF exposure warning
This equipment must be installed and operated in
accordance with provided instructions and the antenna(s)
used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and
must not be co-located or operating in conjunction with
any other antenna or transmitter. End-users and installers
must be provide with antenna installation instructions
and transmitter operating conditions for satisfying RF
exposure compliance.
• Consult the dealer or an experienced radio/TV
technician for help.
CAUTION: This transmitter must not be co-located
or operated in conjunction with any other antenna
or transmitter. Any changes or modifications not
expressly approved by the grantee of this device
could void the user’s authority to operate the
equipment.
IC Radiation Exposure Statement for
Canada
This equipment complies with IC radiation exposure
limits set forth for an uncontrolled environment. To
maintain compliance with IC RF exposure compliance
requirements, please avoid direct contact to the
transmitting antenna during transmitting. End users must
follow the specific operating instructions for satisfying RF
exposure compliance.
Operation is subject to the following two conditions:
• This device may not cause interference and
• This device must accept any interference, including
interference that may cause undesired operation of
the device.
ICES-3(B)-NMB(3)(B)
User should also be advised that:
(i) the device for operation in the band 5150-5250 MHz
is only for indoor use to reduce the potential for harmful
interference to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices
in the bands 5250-5350 MHz and 5470-5725 MHz shall
comply with the e.i.r.p. limit; and
(iii) the maximum antenna gain permitted for devices in
the band 5725-5825 MHz shall comply with the e.i.r.p.
limits specified for point-to-point and non point-to-
point operation as appropriate. High-power radars are
allocated as primary users (i.e. priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and that these
radars could cause interference and/or damage to LE-
LAN devices.
Regional notice for Singapore
This ASUS product complies with
IDA Standards.
Complies with
IDA Standards
DB103778
Wireless Operation Channel for Different
Domains
N. America 2.412-2.462 GHz Ch01 through CH11
Japan 2.412-2.484 GHz Ch01 through Ch14
Europe ETSI 2.412-2.472 GHz Ch01 through Ch13
ASUS Contact Information
ASUSTeK COMPUTER INC.
Address 1F., No. 15, Lide Rd., Beitou Dist., Taipei
City 112, Taiwan
Telephone [phone]
Fax [phone]
Website
http://www.asus.com
Technical Support
Telephone [phone]
Online support
http://qr.asus.com/techserv
ASUS COMPUTER INTERNATIONAL (America)
Address 48720 Kato Rd., Fremont, CA 94538, USA
Telephone [phone]
Fax [phone]
Website
http://www.asus.com/us/
Technical Support
Support fax [phone]
General support [phone]
Online support
http://qr.asus.com/techserv
ASUS COMPUTER GmbH
(Germany and Austria)
Address Harkortstrasse 21-23, 40880 Ratingen,
Germany
Website
http://www.asus.com/de
Online contact
https://www.asus.com/support/
Product/ContactUs/Services/
questionform/?lang=de-de
Technical Support
Telephone (DE) [phone]
Telephone (AT) [phone]
Online support
https://www.asus.com/de/support
FCC COMPLIANCE INFORMATION
Per FCC Part 2 Section 2.1077
Responsible Party:
Asus Computer International
Address:
48720 Kato Rd, Fremont, CA 94538
Phone/Fax No:
[phone]/[phone]
hereby declares that the product
Product Name :
Chromebit
Model Number : CS10
compliance statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Ver. 180620
HDMI Compliance Statement
The terms HDMI, HDMI High-Definition Multimedia
Interface, and the HDMI Logo are trademarks or
registered trademarks of HDMI Licensing Administrator,
Inc.