E1808 Internal Optical Drive Quick Installation Guide In 18 Languages Revised Edition V3 October 2004
Contents Notices ......................................................................... 3 Safety information ......................................................... 5 Installation notices ........................................................ 5 Using the device ............................................................ 6 English .........................................................................
Notices Federal Communications Commission Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. W A R N I N G ! The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations.
Safety information Observe the following precautions before installing and using the drive. Installation notices Do not place this device in an unstable position, or on vibrating surfaces. Do not place this device under direct sunlight, or in humid or damp places. Do not use or place this device near magnetic fields, televisions, or radios to avoid electronic interference that affects drive performance. Do not attempt to disassemble or repair the drive.
Using the device • • • • • • • • • 6 Do not place damaged or warped discs inside the device. A warped disc may break while in use and damage the device. Use of any controls, adjustments, or procedures other than those specified in this manual may result to hazardous radiation exposure. Do not attempt to disassemble the drive. Do not move the device from a cold to a warm or hot environment. Drastic change of temperature is harmful to the device.
English Hardware installation 1. Turn off your computer and any peripheral devices connected to it. 2. Use a grounded wrist strap or touch a safely grounded object or a metal object, such as the power supply case, before handling the optical drive to avoid damaging it due to static electricity. 3. Remove the computer cover. 4. For optical drives with IDE interface, configure the optical drive jumpers to set the device to master or slave mode before installing it into the chassis.
Internal Optical Drive
