User Guide

Specicaon
Connecng the display
Before seng up the client box, please nd the HDMI or VGA input interface.
Aer connecng the input cable, please switch HDMI/VGA signals via the
monitor’s input selecon buon.
Please follow the steps below to connect the client box:
Place the client box on the at surface near the monitor. Let the back/rear
panel facing you to clearly see the back panel I/O ports interface.
1. Plug the power cord to the client box’s power interface and connect
the power adapter to a socket.
2. Connect one end of the HDMI/VGA cable to the client box, the other
end to the monitor’s HDMI/VGA interface.
3. Press the power buon ( ) on top of the client box for 4 seconds.
The monitor will then display the startup screen of the operaon
system.
Model CAX21
CPU ARM quad-core Cortex-A9 1.6GHz
ROM DDRIII 2GB
RAM NAND FLASH 8GB
Network
RJ45 10/100Mbps
WLAN 802.11b/g/n
Bluetooth 4.0
Operang System Android 4.4
I/O port
1x Micro SD slot
1x VGA, 1x HDMI
1x Earphone jack, 1x Microphone jack
3x USB2.0, 1x USB2.0 OTG
Wall mount bracket 75mm
Operang power 6.8W
Stand-By power 3.2W
Operang Temperature
0~40 ℃
Power Supply 15W(5V3A) Power adaptor
Phys. Dimension (W x H x D)
129.5 x 25 x 108 mm
Box Dimension (W x H x D)
290 x 270 x 287 mm
Accessory a
AC Adapter, User guide, Warranty Card
Remote control
Oponal Wall mount bracket
NCC 警語 (以下警語適用台灣地區)
1. 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率
或變更原設計之特性及功能。
2. 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改
善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須
忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a
residenal installaon. This equipment generates, uses and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instrucons, may cause harmful interference to radio communicaons.
However, there is no guarantee that interference will not occur in a parcular installaon. If this equipment does
cause harmful interference to radio or television recepon, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separaon between the equipment and receiver.
● Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
FCC Cauon: Any changes or modicaons not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operaon. This device and its antenna(s) must not be co-located or oper-
ang in conjuncon with any other antenna or transmier.
IMPORTANT NOTE:
FCC Radiaon Exposure Statement:
This equipment complies with FCC radiaon exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
■ ASUSTeK Computer Inc.
■ Technical Support
Address 15 Li-Te Rd. Peitou,
Taipei 11259, Taiwan
Telephone [phone]
Fax [phone]
E-mail [e-mail]
Website hp://www.asus.com/tw/
Telephone [phone]
■ ASUS Computer Internal (America)
■ Technical Support
Address 800 Corporate Way,
Fremont, CA 94539, USA
Fax [phone]
Website hp://www.asus.com/us/
Telephone
(English Only) [phone]
(French Only) [phone]
Online Support hp://support.asus.com/
■ Technical Support
Telephone [phone]
Support Fax [phone]
Online Support hp://support.asus.com/
■ ASUS Computer GmbH
(Germany and Austria)
Address Harkortstr. 21-23
D-40880 Rangen, Germany
Telephone [phone]
Website hp://www.asus.com/de/
ASUS CONTACT INFORMATION
Use Wall mount bracket
Before using the wall mount bracket, please equip a 75x75mm or 100x100mm
VESA wall-mounng compliant display and compable screws.
Please follow the steps below to wall mount the client box:
1. Aach the wall mount bracket to the back of display and x with the
screw to join them ghtly.
2. Connect the hanging hole at the boom of the client box with the cleats
of the wall mount bracket. Slightly pull the client box down to secure it.
設備名稱: 雲客戶機，型號: CAX21
單元
限用物質及其化學符號
鉛
(Pb)
汞
(Hg)
鎘
(Cd)
六價鉻
多溴聯苯
(PBB)
多溴二苯醚
(PBDE)
印刷電路板及電子組件 O O O O O O
其他及其配件 O O O O O O
備考 1.〝○〞係指該項限用物質之百分比含量未超出百分比含量基準值。
｢產品之限用物質含有情況｣之相關資訊，請參考下表
Innovation, Science and Economic Development Canada (ISED)
This device complies with RSS210 of Industry Canada.
CAUTION: Exposure to Radio Frequency Radiation. The installer of this radio equipment must
ensure that the antenna is located or pointed such that it does not emit RF field in excess of
Health Canada limits for the general population. Consult Safety Code 6, obtainable from health
Canada’s website www.hc-sc.ca/rpb.
This device complies with Innovation, Science and Economic Development Canada license-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Ce dispositif est conforme à la norme CNR Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. Son fonctionnement est sujet aux deux
conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif
doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement
indésirable.
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator &
your body.
Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposion aux rayonnements ISED établies pour un environnement
non contrôlé. Cet équipement doit être installé et ulisé avec un minimum de 20 cm de distance entre la source
de rayonnement et votre corps.