User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Watchdog Timer
- 4.4.7 AMT Configuration (on selected models)
- 4.4.8 Super IO Configuration
- 4.4.9 Serial Console Redirection
- 4.4.10 SATA configuration
- 4.4.11 VMD setup menu
- 4.4.12 Network Stack Configuration
- 4.4.13 USB Configuration
- 4.4.14 NVMe Configuration
- 4.4.15 Onboard Devices Configuration
- 4.4.16 APM Configuration
- 4.4.17 EZ-Flash
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 MEBx menu (on selected models)
- 4.10 Updating your BIOS
- Appendix
78
Single Board Computer
USB32G2_1-4
Allows you to enable or disable each USB port. When set to [Disabled], any
USB devices plugged into the connector will not be detected by the BIOS
or OS.
Conguration options: [Disabled] [Enabled]
USB2_5-6
Allows you to enable or disable each USB port. When set to [Disabled], any
USB devices plugged into the connector will not be detected by the BIOS
or OS.
Conguration options: [Disabled] [Enabled]
4.4.14 NVMe Conguration
This menu displays the NVMe controller and drive information of the
connected devices.