User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Watchdog Timer
- 4.4.7 AMT Configuration (on selected models)
- 4.4.8 Super IO Configuration
- 4.4.9 Serial Console Redirection
- 4.4.10 SATA configuration
- 4.4.11 VMD setup menu
- 4.4.12 Network Stack Configuration
- 4.4.13 USB Configuration
- 4.4.14 NVMe Configuration
- 4.4.15 Onboard Devices Configuration
- 4.4.16 APM Configuration
- 4.4.17 EZ-Flash
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 MEBx menu (on selected models)
- 4.10 Updating your BIOS
- Appendix
46
Single Board Computer
3.6 Installing an M.2 SSD
1. (Optional) Replace the stando if it has been removed, or move and
install it based on the length of your M.2 SSD.
2. Align and insert the M.2 SSD into its slot inside the Single Board
Computer.
3. Gently push down the M.2 SSD on top of the stando, and then fasten
it using a screw.