User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Watchdog Timer
- 4.4.7 AMT Configuration (on selected models)
- 4.4.8 Super IO Configuration
- 4.4.9 Serial Console Redirection
- 4.4.10 SATA configuration
- 4.4.11 VMD setup menu
- 4.4.12 Network Stack Configuration
- 4.4.13 USB Configuration
- 4.4.14 NVMe Configuration
- 4.4.15 Onboard Devices Configuration
- 4.4.16 APM Configuration
- 4.4.17 EZ-Flash
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 MEBx menu (on selected models)
- 4.10 Updating your BIOS
- Appendix
Single Board Computer
41
3.1 Installing memory modules
Your motherboard comes with two (2) SO-DIMM memory slots that allow
you to install DDR5 SO-DIMMs.
WARNING! Make sure to unplug the power supply before adding or
removing DIMMs or other system components. Failure to do so may
cause severe damage to both the motherboard and the components.
Align and insert the memory module into the slot (A) and press it down (B)
until it is securely seated in place.