User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 LVDS Configuration
- 4.4.2 PCH-FW Configuration
- 4.4.3 Trusted Computing
- 4.4.4 CPU Configuration
- 4.4.5 Graphics Configuration
- 4.4.6 Watchdog Timer
- 4.4.7 AMT Configuration (on selected models)
- 4.4.8 Super IO Configuration
- 4.4.9 Serial Console Redirection
- 4.4.10 SATA configuration
- 4.4.11 VMD setup menu
- 4.4.12 Network Stack Configuration
- 4.4.13 USB Configuration
- 4.4.14 NVMe Configuration
- 4.4.15 Onboard Devices Configuration
- 4.4.16 APM Configuration
- 4.4.17 EZ-Flash
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 MEBx menu (on selected models)
- 4.10 Updating your BIOS
- Appendix
Single Board Computer
21
2.5 Internal connectors
1. LVDS EDP Signal connector (on selected models)
The LVDS EDP Signal connector allows you to connect an internal
embedded DisplayPort.
NOTE:
• When using an LVDS panel, connect pin 3 from this connector to a
GND pin on the LVDS panel.
• When using an EDP panel, keep pin 3 disconnected.
Connector type
WtoB CON 2x 20P G/F 1.25 BLK S/T SMT
ACES/50286-04071-001