User Manual
Table Of Contents
- About this manual
- Chapter 1: Specifications Summary
- Chapter 2: Product Introduction
- Chapter 3: Upgrading your Single Board Computer
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 PCH-FW Configuration
- 4.4.2 Trusted Computing
- 4.4.3 CPU Configuration
- 4.4.4 Graphics Configuration
- 4.4.5 Watchdog Timer
- 4.4.6 AMT Configuration (on selected models)
- 4.4.7 Super IO Configuration
- 4.4.8 Serial Console Redirection
- 4.4.9 SATA configuration
- 4.4.10 VMD setup menu
- 4.4.11 Network Stack Configuration
- 4.4.12 USB Configuration
- 4.4.13 NVMe Configuration
- 4.4.14 Onboard Devices Configuration
- 4.4.15 APM Configuration
- 4.4.16 EZ-Flash
- 4.5 Hardware Monitor menu
- 4.6 Security menu
- 4.7 Boot menu
- 4.8 Exit menu
- 4.9 MEBx menu
- 4.10 Updating your BIOS
- Appendix
Single Board Computer
65
4.4.7 Super IO Conguration
The items in this menu allow you to congure system super IO chip
parameters.
NCT6126D Super IO Conguration
Serial Port 1-2 Conguration
Allows you to set the parameters of Serial Port 1-2.
Serial Port
Allows you to enable or disable Serial Port.
Conguration options: [Disabled] [Enabled]
NOTE: The following items appear only when Serial Port is set to
[Enabled].
COM1-2 Control
Conguration options: [RS232] [RS485] [RS422]
Serial Port 3-4 Conguration
Allows you to set the parameters of Serial Port 3-4.
Serial Port
Allows you to enable or disable Serial Port.
Conguration options: [Disabled] [Enabled]