User's Manual
8
USB LED
O:
• NoUSBdeviceconnected.
• Ejectprocessiscompleted.
Flashing:
• Blinking once every 0.2 second: The USB device is transmitting data.
• Blinking once every 1.4 seconds: Eject process is initiated.
• Every 0.3-second blink followed by three 0.1-second blinks: Eject process is
under processing.
Failover LED
O: Failover feature is disabled, or failover feature is enabled but not active.
On: Failover feature is enabled and active.
USB eject button
Press and hold this button until the USB LED is off to safely remove the USB device.
SSD LED
O: No SSD device connected.
Flashing: SSD devices are running.
USB 3.0 port
Insert USB 3.0 devices such as USB hard disks or USB flash drives into this port.
WAN (Internet) 1/2 ports
Connect a network cable into these ports to establish WAN connection.
WPS button
This button launches the WPS Wizard.
LAN 1 ~ 8 ports*
Connect network cables into these ports to establish LAN connection.
Reset button
This button resets or restores the system to its factory default settings.
Power button
Press this button to power on or off the system.
Power (DC-IN) port
Insert the bundled AC adapter into this port and connect your router to a power source.
M.2 SSD socket
This socket allows you to install an M.2 (NGFF) SSD module. It supports type
2280/2260/2242 storage devices.
* NOTES:
• UseLANports1to4forIPTVconnection.
• OnlyLANports5to8canbeconguredtofunctionasWANports.