User guide

Viglen Genie Executive pBTX 915 User Guide V1.0
42
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology. Configuration
options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Disabled]
Enables or disables 32-bit data transfer. Configuration options: [Disabled] [Enabled]
IDE Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press <Enter> if you want to
configure the item.
Figure 56: IDE Configuration Screen
Configure SATA As [Standard IDE]
Set SATA controller to IDE mode. Configuration options: [Standard IDE]
Onboard IDE Operate Mode [Enhanced Mode]
Allows selection of the IDE operation mode depending on the operating system (OS)
that you installed. Set to Enhanced Mode if you are using native OS, such as
Windows® 2000/XP. Configuration options: [Disabled] [Compatible Mode]
[Enhanced Mode]
Enhanced Mode Support On [SATA ]
Allows you to use native OS on Serial ATA and Parallel ATA ports. In this setting,
you may use legacy OS on the Parallel ATA ports only if you did not install any Serial
ATA device.
Note: The following item appears only when you set the Onboard IDE OperateMode
to [Compatible Mode].
Combined Mode Option [Secondary P-ATA+S-ATA]
Allows you to use choose the IDE ports to be used. If you select Primary P-ATA+S-
ATA, the system will only support SATA2 and SATA4 in Combined mode.
The S-ATA only and P-ATA only options are for advanced users only. If you set to
any of these options and encounter problems, revert to the default setting
[Secondary P-ATA+S-ATA]. Configuration options: [Secondary P-ATA+S-ATA] [S-
ATA only] [P-ATA only]