User guide

Viglen Genie Executive pBTX 915 User Guide V1.0
33
Figure 45: IDE Connector
Serial ATA Connector (7-pin SATA)
This connector is for the Serial ATA signal cable for a Serial ATA hard disk drive.
Figure 46: SATA Connectors
CPU Fan Connectors (3-pin CPU_FAN1, 3-pin CPU_FAN2)
The fan connectors support cooling fans of 350 mA~740 mA (8.88 W max.) or a total
of 1 A~2.22 A (26.64 W max.) at +12V. Connect the fan cables to the fan connectors
on the motherboard, making sure that the black wire of each cable matches the
ground pin of the connector.
CAUTION: Do not forget to connect the fan cables to the fan
connectors. Insufficient air flow inside the system may damage the
motherboard components. These are not jumpers!! Do not place
jumper caps on the fan connectors!!