User guide

Viglen Genie Executive pBTX 915 User Guide V1.0

Figure 43: Keyboard Power Setting

Connectors

Floppy Disk Drive Connector

This connector is for the provided floppy disk drive (FDD) signal cable. Insert one

end of the cable to this connector, and then connect the other end to the signal

connector at the back of the floppy disk drive.

Figure 44: Floppy Disk Drive Connector

Primary IDE Connector (40-1 pin PRI_IDE)

This connector is for an Ultra DMA 100/66 signal cable. The Ultra DMA 100/66 signal

cable has two connectors: a blue connector for the primary IDE connector on the

motherboard and a black connector for an Ultra DMA 100/66 IDE slave device

(optical drive/hard disk drive).

Note: Pin 20 on the IDE connector is removed to match the covered hole on the

Ultra DMA cable connector. This prevents incorrect insertion when you connect the

IDE cable. Use the 80-conductor IDE cable for Ultra 100/66 IDE device.