User guide

Viglen Genie Executive pBTX 915 User Guide V1.0

6. Connect a 15-pin Serial ATA power plug from the power supply unit to the power

connector at the back of the drive. Or connect a 4-pin (female) power plug from

the power supply unit to the 4-pin (male) power connector at the back of the

drive.

CAUTION: If the Serial ATA hard disk drive has both 4-pin and 15-pin

connectors at the back, use either the 15-pin Serial ATA power adapter

plug or the legacy 4-pin power connector. DO NOT

use both to prevent

damage to components and to keep the system from becoming

unstable.

Replacing the Front Bezel and Top Cover

After installing all system components and connecting all the cables, replace the

front bezel and system cover by following these instructions.

1. Fasten the front bezel hooks to the chassis holes until they fit in place.

Figure 35: Reinstalling the Front Bezel

2. Position the cover at least two inches from the front panel, and then align the

cover hooks to the chassis rail.

Figure 36: Reinstalling the Top Cover

3. Push the system cover towards the front panel until it fits in place.

4. Secure the system cover with the screws you removed earlier.