User guide

Viglen Genie Executive pBTX 915 User Guide V1.0
27
Installing a Hard Disk Drive
The Viglen Genie Executive pBTX supports one Serial ATA hard disk drive.
To install a Serial ATA hard disk drive, follow the below procedure:
1. Slightly lift the storage drive assembly.
2. With the hard disk drive label side up, carefully insert the drive into the 3.5” bay.
Figure 32: Inserting the Hard Disk Drive
3. Push the drive into the bay until its screw holes align with the holes on the bay.
Figure 33: Aligning the Hard Disk Drive Holes
4. Secure the hard disk drive with two screws.
5. Connect one end of the Serial ATA cable to the SATA connector at the back of
the drive, and then connect the other end to the Serial ATA connector on the
motherboard.
Figure 34: Connecting the Serial ATA Cable