User guide

Viglen Genie Executive pBTX 915 User Guide V1.0
13
Removing the Top Cover and Front Bezel
To remove the cover:
1. Locate the two screws that secure the foot stands to the cover and the chassis.
Figure 6: Removing the foot stand screws
2. Remove the screws using a Phillips screw driver. Keep the screws for later use
and set the foot stands aside.
3. On the rear panel, locate the two screws that secure the cover to the chassis.
Figure 7: Removing the Top Cover Screws
4. Remove the cover screws using a Phillips screw driver. Keep the screws for later
use.
Figure 8: Removing the Top Cover Lid
5. Push the cover slightly toward the rear panel until the cover tabs disengage from
the chassis.
6. Lift the cover, and set it aside.