Service manual

7 - 4 Genie GS-1530 & Genie GS-1930 Part No. 39528
Service Manual - First Edition
Section 7 - Repair Procedures
a
c
d
e
f
b
How to Set the DIP Switch Codes
Tip-over hazard. Do not adjust the
DIP switch settings to other than
what is specified in this procedure.
Exceeding specifications will
cause death or serious injury.
If replacing the circuit board, note
the toggle positions on the DIP
switch. Set the DIP switch on the
new circuit board to the same
configuration of the old one.
1 Push in the Emergency Stop button to the OFF
position at the ground and platform controls.
Turn the key switch to the OFF position.
2 Remove the fasteners securing the top of the
controller to the controller case.
3 Rotate the platform controller box in the
position shown to correctly identify the
configuration of the DIP switch settings.
4 Open the controller box lid and locate the DIP
switch on the circuit board. Move the DIP
switch settings to correspond with the
configuration of the machine options, indicated
in the DIP Switch Code Chart .
a DIP switch
b Emergency stop button
c Circuit boards
d Joystick controller
e Controller box
f Enlarged view of DIP switch
5 Close the lid and install the fasteners.
6 Confirm the settings. See 1-2, How to
Determine the Revision Level .
7 Push in the Emergency Stop button to the OFF
position at both the ground and platform
controls and turn the key switch to the OFF
position.
Any change in DIP settings will
not take effect until the key switch
is turned to the OFF position.
PLATFORM CONTROLS