Service manual

Part No. 39528 Genie GS-1530 & Genie GS-1930 4 - 7
Service Manual - First Edition Section 4 - Scheduled Maintenance Procedures
A-10
Test the Lift/Drive Select Switch
(before serial number 17408)
A properly functioning Lift/Drive Select Switch
is essential for safe machine operation. An
improperly operating Lift/Drive Select Switch
will fail to activate the appropriate platform control
which may result in a hazardous situation.
1 Turn the key switch to platform control and pull
out the Emergency Stop button to the ON
position at both the platform and ground
controls.
2 Move the lift/drive select switch to the LIFT
position.
3 Press and hold the function enable switch.
Result: The green power light should come on.
4 Slowly move the control handle off center.
Result: The platform should raise or lower.
5 Move the lift/drive select switch to the DRIVE
position.
6 Press and hold the function enable switch.
Result: The green power light should come on.
7 Slowly move the control handle off center.
Result: The drive and steer functions should
operate.
A-11
Perform 30 Day Service
The 30 day maintenance procedure is a onetime
sequence of procedures to be performed after the
first 30 days or 50 hours of usage. After this
interval, refer to the maintenance tables for
continued scheduled maintenance.
1 Perform the following maintenance procedures:
· B-3 Inspect Tires and Wheels
· C-1 Replace the Hydraulic Filter
TABLE A PROCEDURES