Service manual

Part No. 39528 Genie GS-1530 & Genie GS-1930 7 - 41
Service Manual - First Edition Section 7 - Repair Procedures
7 Adjust the internal hex socket. Turn it clockwise
to increase the pressure or counterclockwise to
decrease the pressure. Install the relief valve
cap.
Tip-over hazard. Do not adjust
the relief valves higher than
recommended.
8 Repeat steps 3 through 6 to recheck the valve
pressure.
Steering relief valve specification
Pressure 1200 psi 82.8 bar
How to Check the Resistance
of a Valve Coil
1 Turn the key switch to the OFF position and
disconnect the wire from the valve coil to be
tested.
2 Connect the positive lead from the ohmmeter to
the valve coil terminal, then connect the
negative lead from the ohmmeter to the internal
ring of the valve coil.
Function manifold valve coil specifications
3 position 4 way solenoid valve 26 - 28W
(schematic item F)
2 position 2 way solenoid valve 26 - 28W
(schematic item I)
2 position 4 way solenoid valve 18 - 20W
(schematic item G)
3 position 4 way solenoid valve 18 - 20W
(schematic item J)
FUNCTION MANIFOLD