Service manual

Part No. 39528 Genie GS-1530 & Genie GS-1930 7 - 27
Service Manual - First Edition Section 7 - Repair Procedures
18 Install the new wear pad.
Note the position of the old wear
pad before it is removed so when
the new one is installed it will be in
the correct position.
19 Move the scissor assembly towards the other
side of the machine until the other scissor arm
wear pad is accessible.
The scissor assembly will fall if
both wear pads are allowed to
slide out of the drive chassis.
20 Install the new wear pad.
Note the position of the old wear
pad before it is removed so when
the new one is installed it will be in
the correct position.
21 Slide the scissor assembly back into the drive
chassis.
22 Lower the scissor assembly into position and
install the pivot pins.
Component damage hazard. Be
careful not to damage the level
sensor box, limit switch or level
sensor while installing the scissor
assembly.