Service manual

7 - 24 Genie GS-1530 & Genie GS-1930 Part No. 39528
Service Manual - First Edition
Section 7 - Repair Procedures
SCISSOR COMPONENTS
14 Lower the cylinder onto the number 1 center
pivot pin (index #9).
15 Attach a lifting strap from an overhead crane to
number 3 inner arm (index #4).
16 Remove the external snap rings from the
number 3 pivot pin (index #5).
17 Use a soft metal drift to remove the number 3
pivot pin (index #5). Remove the number 3
inner arm (index #4) from the machine.
Bodily injury hazard. The number
3 inner arm (index #4) may
become unbalanced and fall if not
properly supported when it is
removed from the machine.
18 Attach a lifting strap from an overhead crane to
the number 2 outer arm (index #15).
19 Remove the external snap rings from the
number 2 center pivot pin (index #6) at the
battery pack side.
20 Use a soft metal drift to remove both of the
number 2 center pivot pins (index #6).
21 Remove the external snap rings from the
number 2 pivot pin (index #16).
22 Use a soft metal drift to remove the number 2
pivot pin (index #16). Remove the number 2
outer arm (index #15) from the machine.
Bodily injury hazard. The number
2 outer arm (index #15) may
become unbalanced and fall if not
properly supported when it is
removed from the machine.
23 Attach a lifting strap from an overhead crane to
the number 2 inner arm (index #7).
24 Remove the external snap rings from the
number 2 pivot pin (index #8).
25 Use a soft metal drift to remove the number 2
pivot pin (index #8). Remove the number 2
inner arm (index #7) from the machine.
Bodily injury hazard. The number
2 inner arm (index #7) may
become unbalanced and fall if not
properly supported when it is
removed from the machine.
26 Remove the safety arm from the number 2
inner arm (index #7) that was just removed.
27 Attach the strap from the overhead crane to the
number 1 inner arm (index #10).
28 Raise the number 1 inner arm (index #10)
approximately 2 feet (0.6 m) and insert the
safety arm between the number 1 inner arm
(index #10) and the number 1 outer arm
(index #18).
Bodily injury hazard. Keep hands
clear of moving parts when
inserting the safety arm.
29 Disconnect and plug the hydraulic hose on the
lift cylinder. Cap the fitting on the cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.