Service manual

Part No. 39528 Genie GS-1530 & Genie GS-1930 7 - 21
Service Manual - First Edition Section 7 - Repair Procedures
How to Replace the Scissor Arm
Wear Pads
(before serial number 632)
1 Remove the platform. See 2-1, How to Remove
the Platform.
2 Carefully slide the forks from a forklift under the
scissor arms at the non-steer end of the
machine.
3 Attach a strap from the scissor arms to the
carriage on the forklift for support.
4 Remove the pin retaining fasteners from the
number 1 inner arm pivot pins. Use a slide
hammer to remove the pins.
5 Remove the fasteners from the level sensor
box. Remove the box.
6 Remove the fasteners from the level sensor.
Remove the level sensor.
7 Slide the scissor assembly towards the non-
steer end of the machine approximately 18
inches (45.7 cm).
8 Remove the mounting fasteners from the
stationary wear pads on the platform and at the
steer end of the chassis.
Note the position of the old wear
pads before they are removed so
when the new ones are installed
they will be in the correct position.
9 Install the new wear pads with new fasteners.
10 Slide the movable wear pads off of the number
4 inner arm (index #3) and the number 1 outer
arm (index #21). Install the new wear pads.
11 Re-assemble machine in reverse order in which
it was disassembled.
SCISSOR COMPONENTS