Service manual

7 - 18 Genie GS-1530 & Genie GS-1930 Part No. 39528
Service Manual - First Edition
Section 7 - Repair Procedures
15 Attach a lifting strap from an overhead crane to
the number 3 outer arm (index #18).
16 Remove the pin retaining fasteners from the
number 3 center pivot pin (index #5) at the
ground controls side.
17 Remove the external snap ring. Use a slide
hammer to remove the pin.
Bodily injury hazard. The number
3 outer arm (index #18) may
become unbalanced and fall if not
properly supported when the
center pivot pin is removed.
18 Remove the pin retaining fasteners from the
number 3 pivot pin (index #19) at the non-steer
end.
19 Remove the external snap ring. Use a slide
hammer to remove the pin.
Bodily injury hazard. The number
3 outer arm (index #18) may
become unbalanced and fall if not
properly supported when it is
removed.
20 Repeat steps 16 through 19 for the battery
pack side of the machine.
21 Remove the fasteners from the lower cable tray
support at the steer end.
22 Remove the pin retaining fasteners from the
number 2 center pivot pin (index #9) at the
ground controls side. Do not remove the pin.
23 Slide the cable tray towards the battery pack
side of the machine and remove it from the
machine and lay it off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
24 Attach a lifting strap from an overhead crane to
lug on the rod end of the lift cylinder to support
it.
25 Remove the external snap ring from the
cylinder rod-end pivot pin (index #6). Use a soft
metal drift to remove the pin.
Bodily injury hazard. The cylinder
may fall if not properly supported
when the pin is removed.
26 Lower the cylinder onto the number 1 center
pivot pin (index #12).
27 Attach a lifting strap from an overhead crane to
the number 3 inner arm (index #7).
28 Remove the pin retaining fasteners from the
number 3 pivot pin (index #8) at the steer end
of the machine at the ground controls side.
29 Remove the external snap ring. Use a slide
hammer to remove the pin.
Bodily injury hazard. The number 3
inner arm (index #7) may fall if not
properly supported when the pins
are removed.
30 Repeat steps 28 and 29 for the battery pack
side.
31 Attach a strap from an overhead crane to the
number 2 outer arm (index #20) at the ground
controls side.
32 Remove the pin retaining fasteners from the
number 2 center pivot pin (index #9) at the
ground controls side.
33 Remove the external snap ring. Use a slide
hammer to remove the pin.
SCISSOR COMPONENTS