Service manual

Part No. 39528 Genie GS-1530 & Genie GS-1930 7 - 17
Service Manual - First Edition Section 7 - Repair Procedures
3-2
Scissor Assembly,
GS-1930 Models
(before serial number 632)
How to Disassemble the
Scissor Assembly
GS-1930 Models
(before serial number 632)
The procedures in this section
require specific repair skills, lifting
equipment and a suitable
workshop. Attempting this
procedure without these skills and
tools may result in death or
serious injury and significant
component damage. Dealer
service is required.
Follow the disassembly steps to the point required
to complete the repair. Then re-assemble the
scissor assembly by following the disassembly
steps in reverse order.
1 Remove the platform. See 2-1, How to Remove
the Platform.
2 Remove the cables from the side of the outer
platform support arm (index #16) at the ground
controls side.
3 Remove the retaining fasteners from the center
pivot pins (index #2) at both the ground
controls side and the battery pack side. Do not
remove the pins.
4 Remove the upper cable tray and lay off to the
side.
Component damage hazard.
Cables can be damaged if they are
kinked or pinched.
5 Attach a lifting strap from an over head crane to
the steer-end outer platform support arm (index
#16).
6 Remove the external snap ring from the number
4 center pivot pin (index #2) at the ground
controls side. Use a slide hammer to remove
the pin.
7 Remove the pin retaining fasteners from the
number 4 pivot pin (index #17) at the non-steer
end the machine at the ground controls side.
8 Remove the external snap ring from the number
4 pivot pin (index #17) at the ground controls
side. Use a slide hammer to remove the pin.
9 Repeat steps 6 through 8 for the battery pack
side of the machine.
10 Remove the arm from the machine.
Bodily injury hazard. The number
4 outer arm (index #16) may
become unbalanced and fall if not
properly supported when it is
removed from the machine.
11 Attach a lifting strap from an overhead crane to
the number 4 inner arm (index #3).
12 Remove the pin retaining fasteners from the
number 4 pivot pin (index #4) at both sides of
the machine.
13 Remove the external snap ring from the
number 4 pivot pin (index #4). Use a slide
hammer to remove the pin.
14 Repeat steps 11 and 12 for the battery pack
side of the machine.
Bodily injury hazard. The number
4 inner arm (index #3) may
become unbalanced and fall if not
properly supported when it is
removed.
SCISSOR COMPONENTS