Service manual

7 - 12 Genie GS-1530 & Genie GS-1930 Part No. 39528
Service Manual - First Edition
Section 7 - Repair Procedures
SCISSOR COMPONENTS
14 Lower the cylinder onto the number 1 center
pivot pin (index #9).
15 Attach a lifting strap from an overhead crane to
number 3 inner arm (index #4).
16 Remove the pin retaining fasteners from the
number 3 pivot pin (index #5). Do not remove
the pin.
17 Remove the external snap ring. Use a slide
hammer to remove the pin.
18 Repeat steps 16 and 17 for the battery pack
side.
Bodily injury hazard. The number
3 inner arm (index #4) may
become unbalanced and fall if not
properly supported when the pins
are removed.
19 Attach a strap from an overhead crane to the
number 2 outer arm (index #15).
20 Remove the pin retaining fasteners from the
number 2 center pivot pin (index #6) at the
ground controls side.
21 Remove the external snap ring. Use a slide
hammer to remove the pin.
22 Remove the pin retaining fasteners from the
number 2 pivot pin (index #16) at the ground
controls side.
23 Remove the external snap ring. Use a slide
hammer to remove the pin.
24 Repeat steps 20 through 23 for the battery pack
side of the machine. Remove the arm from the
machine.
Bodily injury hazard. The number
2 outer arm (index #15) may
become unbalanced and fall if not
properly supported when the pins
are removed.
25 Attach a lifting strap from an overhead crane to
the number 2 inner arm (index #7).
26 Remove the pin retaining fasteners from the
number 2 pivot pin (index #8).
27 Remove the external snap ring. Use a slide
hammer to remove the pin.
28 Repeat steps 26 and 27 for the battery pack
side of the machine. Remove the arm from the
machine.
Bodily injury hazard. The number
2 inner arm (index #7) may
become unbalanced and fall if not
properly supported when the pins
are removed.
29 Remove the retaining fasteners on the safety
arm from the number 2 inner arm (index #7)
that was just removed.
30 Attach the strap from the crane to the number 1
inner arm (index #10).
31 Raise the number 1 inner arm (index #10)
approximately 2 feet (0.6 m) and insert the
safety arm between the number 1 inner arm
(index #10) and the number 1 outer arm
(index #18).
Bodily injury hazard. Keep hands
clear of moving parts when
inserting the safety arm.