User Guide
Table Of Contents
- Contents
- Notices
- Safety information
- Care & Cleaning
- Takeback Services
- Product information for EU energy label
- Chapter 1: Product introduction
- 1.1 Welcome!
- 1.2 Package contents
- 1.3 Monitor introduction
- Chapter 2: Setup
- 2.1 Assembling the monitor arm/base
- 2.2 Detaching the arm/base (for VESA wall mount)
- 2.3 Attaching/Removing the MiniPC Kit
- 2.4 Adjusting the monitor
- 2.5 Adjusting the webcam
- 2.6 Connecting the cables
- 2.7 Turning on the monitor
- 2.8 Setting up the monitor webcam as default setting
- 2.9 Setting up the monitor speaker as default setting
- Chapter 3: General instructions
- 3.1 OSD (On-Screen Display) menu
- 3.2 Specifications summary
- 3.3 Outline dimensions
- 3.4 Troubleshooting (FAQ)
- 3.5 Supported operating modes
2-5ASUS BE Series LCD Monitor
2.6 Connecting the cables
Connect the cables as the following instructions:
• To connect the power cord: Connect one end of the power cord securely to
the monitor’s AC input port, the other end to a power outlet.
• To connect the VGA/DVI/DisplayPort/HDMI cable:
a. Plug one end of the VGA/DVI/DisplayPort/HDMI cable to the monitor’s
VGA/DVI/DisplayPort/HDMI jack.
b. Connect the other end of the VGA/DVI/DisplayPort/HDMI cable to your
computer's VGA/DVI/DisplayPort/HDMI jack.
c. Tighten the two screws to secure the VGA/DVI connector.
• To connect the audio cable: connect one end of the audio cable to the
monitor’s Audio-in port, the other end to the computer’s audio-out port.
• To use the earphone: connect the end with plug type to the monitor’s
earphone jack when an HDMI or DisplayPort signal is fed.
• To use the USB 3.2 Gen 1 ports: Take the supplied USB Type-B to Type-A
cable, and plug the smaller end (type B) of the USB upstream cable to the
monitor’s USB upstream port, and the larger end (type A) to your computer’s
USB 3.2 Gen 1 port. Make sure your computer is installed with the lastest
Windows 7/Windows 8.1/Windows 10 operating system. That will enable the
USB ports on the monitor to work.