User Manual

the version shows “1.00” then the firmware fix was not successful.
Please reattempt the steps above and try again.
•
• Note: If either SoM shows version “0.08” then you are using Private
Preview hardware this is not compatible with this firmware update and
tool.
b. Apply firmware update to ONLY the Audio Accessory SoM:
i. Connect ONLY the Audio Accessory SoM to the Azure Percept DK.
ii. Ensure Power is on.
iii. Navigate to /home folder
• Ex: cd /home
iv. Run the update tool via the following SSH command
“sudo ./AP_Peripheral_Installer_v0.1”
• The update will run, you will see the output “Complete” when the
update is complete.
v. After, via SSH check the firmware version of the Audio Accessory:
• To check the Audio Accessory firmware version “lsusb -d 045e:0673 -v”
• The output should look like the below for the Audio Accessory, please
confirm that the “bcdDevice” section has the version number “3.00”. If
the version shows “1.00” then the firmware fix was not successful.
Please reattempt the steps above and try again.
•
• Note: If the SoM shows version “0.08” then you are using Private
Preview hardware that is not supported by this firmware update and
tool.
c. Apply firmware update to ONLY the Camera SoM:
i. Connect ONLY the Camera SoM to the Azure Percept DK.
ii. Ensure Power is on
iii. Navigate to /home folder
• Ex: cd /home