User Guide

Running RAID Assist 4-25
Version 1.0 Copyright © 2001-2003 by LSI Logic Corporation. All rights reserved.
Figure 4.24 Stripe Size Selection Warning
If you select Yes, the new configuration will be applied and an 8 KB
cache line size will be active.
If you select No, the Logical Drives page of the Manual Configuration
Wizard will open. You can change the stripe size in order to obtain
the desired cache line size.
7. Select a cache line size (Mylex Controllers Only), if enabled.
Available settings will depend on the selected stripe size.
8. Click the Add Drive button to register your new logical drive.
9. Click Apply to save the configuration if you are finished setting up
logical drives, OR
Repeat the process above to set up additional logical drives, then
click Apply when you’re done.
An example of a completed Manual configuration is shown in
Figure 4.25:
Figure 4.25 Sample Manual Configuration Just Before “Apply”