User Guide

4-14 Configuration
Version 1.0 Copyright © 2001-2003 by LSI Logic Corporation. All rights reserved.
Figure 4.12 Select “New Configuration”
Assisted Configuration walks you step by step through a new
configuration (Figure 4.13). Each “tab” in the Assisted Configuration
dialog box collects information about an important aspect of the
configuration you wish to set up. During this process, you provide
answers to several questions.
4.5.3.1 Fault Tolerance Tab
Configure the following options (Figure 4.13) for fault tolerance.
1. Do you want Fault Tolerance? [Yes/No]
2. Do you want a Hot Spare? [Yes/No]