User Guide

4-12 Configuration

Figure 4.10 Automatic Configuration->New Configuration->Finish

Do the following:

1. Examine the Configuration Summary for details about the

configuration that RAID Assist will set up.

2. If you want to start over, click the Back or Cancel button, or the

Welcome tab, OR

If you want to view the configuration before it is applied to the

controller, click the Details button. You will be taken to an equivalent

of the Disk Arrays page as shown in Manual Configuration, except

that you can only view and close the details window.

3. If you accept the configuration as presented, click the Apply button

at the Finish page to apply the new configuration to the controller.

A warning confirmation box appears as shown in Figure 4.11.