User Guide

3-26 Startup and Navigation
Version 1.0 Copyright © 2001-2003 by LSI Logic Corporation. All rights reserved.
4. If you need to enter a Message Prefix, Suffix, or Delay interval, click
Advanced. Type the desired information and click OK to return to the
Pager setup box.
5. To test the pager using the settings you’ve input, click Test.
6. When you are satisfied with the Pager you’ve set up, click OK.
Your new Pager entry displays in the lower window of the Alarm
Setup dialog box. (Refer to Figure 3.20 for an example.)
3.7.2.2 Remove a Pager
1. Select the Pager alarm type in the upper window of Alarm Setup.
2. Select the Pager entry to remove in the lower window of Alarm
Setup.
3. Click Remove.
A confirmation message is displayed as shown in Figure 3.22.
Figure 3.22 Remove Pager Entry Message
4. Click Yes to remove the Pager entry, or click No to keep the entry.
3.7.2.3 Add a Fax Using Windows
For fax notification Microsoft Exchange and Microsoft At Work Fax
software must be installed on your system. GAM TT supports only
Microsoft At Work Fax under Windows 95. The Software field is not
selectable.
The required fax software components should already be available as
part of the normal Windows installation.
To add a fax, follow these steps.
1. Select the Fax alarm type in the upper window of the Alarm Setup
dialog box (Figure 3.23).