User Guide

Loading a Configuration from Disk 4-47
Version 1.0 Copyright © 2001-2003 by LSI Logic Corporation. All rights reserved.
Figure 4.49 Creating a Spanned Array
You can now configure the desired number of logical drives.
Select the Logical Drives tab to configure your disk arrays into logical
drives. It works the same as Manual/New (see Section 4.5.4, “Manual
Configuration,” page 4-21). Note that the only logical drives that will be
spanned are those whose capacity is taken from more than 1 array. If the
logical drive size created uses less that the capacity available on the
channel, the spanning will not take place.
4.17 Loading a Configuration from Disk
Load a previously-saved configuration from disk as shown in Figure 4.50.
Figure 4.50 Select “Open Configuration”
1. In the Open Configuration dialog box (Figure 4.51), select the
configuration file you wish to open to save to the controller.