User Guide

If any of these items are missing, please follow the instructions below to install them

properly:

Set up the Network Protocols:

• Click “Add” and select “Protocol” on Network “Configuration”.

• Click “Add” and then choose the network protocol. Select Microsoft as the

manufacturer and “NetBEUI”, “TCP/IP”, and “IPX/SPX-compatible” for the network

protocols. Then click “OK;”

• Now your network protocol should be set. Please check if your network needs

any special requirements to operate in your office environment.

•

Additional Note for Windows 2000 to install packet protocol

You should add Packet Protocol under Windows 2000.If the Packet Protocol doesn’t

exist in your system, after clicking WLAN Utility, system will prompt a message to

guide you to install Packet Protocol. Follow the procedure to complete this

installation and reboot your system.