User Manual
Table Of Contents
- Notices
- Safety information
- About this guide
- AT5NM10T-I specifications summary
- Chapter 1
- Product introduction
- Chapter 2
- BIOS information
1-15 Chapter 1: Product introduction
11. Serial port connector (10-1 pin COM2)
The connector is for a serial (COM) port. Connect the serial port module cable to the
connector, then install the module to a slot opening at the back of the system chassis.
The serial port bracket is purchased separately.
12. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect
the S/PDIF Out module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
The S/PDIF module is purchased separately.
AT5NM10T-I
AT5NM10T-I Serial port (COM2) connector
PIN 1
COM2
AT5NM10T-I
AT5NM10T-I Digital audio connector
+5V
SPDIFOUT
GND