User Guide

20
LED projector E-Manual
Emergency light mode
The LED projector ashes a blinking white light when you use this
feature.
Back/Splendid
button
To use your LED projector as a ashlight:
1. Disconnect all peripherals from your LED projector then press
the power button to turn it on.
2. Press on the control panel of your LED projector to launch
the NO SIGNAL display.
3. Press repeatedly until the LED projector ashes a blinking
white light.
IMPORTANT! Ensure that your LED projector is charged and can run
on battery mode before enabling this feature. Battery time varies
depending on usage.
NOTE: To turn o or switch between the ashlight and emergency
light feature of your LED projector, just press the Back/Splendid
button until your preferred lighting feature is disabled or enabled.