User’s Manual
Table Of Contents
- 本マニュアルについて
- Chapter 1:ハードウェアのセットアップ
- Chapter 2:ノートパソコンを使用する
- Chapter 3:Windows® 8環境で使用する
- Chapter 4:ASUSアプリ
- Chapter 5:Power-on Self-test(POST)
- Chater 6:付録
- 光学ドライブ情報
- 内蔵モデムの適応規格(規格/プロトコルなど原文掲載)
- Overview
- Network Compatibility Declaration
- Network Compatibility Declaration
- Non-Voice Equipment
- Federal Communications Commission Statement
- FCC Radio Frequency (RF) Exposure Caution Statement
- Declaration of Conformity (R&TTE directive 1999/5/EC)
- CE Marking
- IC Radiation Exposure Statement for Canada
- Wireless Operation Channel for Different Domains
- France Restricted Wireless Frequency Bands
- UL Safety Notices
- Power Safety Requirement
- TV Tuner Notices
- REACH
- Nordic Lithium Cautions (for lithium-ion batteries)
- Optical Drive Safety Information
- CTR 21 Approval (for Notebook PC with built-in Modem)
- 技適マーク
- ENERGY STAR complied product
- European Union Eco-label
- Prevention of Hearing Loss
- Global Environmental Regulation Compliance and Declaration
- 回収とリサイクルについて
- 筐体のコーティングについて
- 光学ドライブ情報

ノートパソコン ユーザーマニュアル
93
This information was copied from CETECOM and is supplied
without liability. For updates to this table, you may visit http://
www.cetecom.de/technologies/ctr_1.html
1 National requirements will apply only if the equipment may
use pulse dialling (manufacturers may state in the user guide
that the equipment is only intended to support DTMF signalling,
which would make any additional testing superuous).
In The Netherlands additional testing is required for series
connection and caller ID facilities.
Federal Communications Commission Statement
This device complies with FCC Rules Part 15. Operation is subject
to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a class B digital device, pursuant to Part 15 of
the Federal Communications Commission (FCC) rules. These
limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of
the following measures: