TS100-E8-PI4 Manual
Table Of Contents
- Contents
- Chapter 1: Product introduction
- Chapter 2: Hardware setup
- Chapter 3: Motherboard Info
- 3.1 Motherboard layout
- 3.2 Jumpers
- 3.3 Internal connectors
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 CPU Configuration
- 4.4.2 PCH-IO Configuration
- 4.4.3 SATA Configuration
- 4.4.4 System Agent (SA) Configuration
- 4.4.5 PCI Subsystem Settings
- 4.4.6 USB Configuration
- 4.4.7 TPM
- 4.4.8 ACPI Settings
- 4.4.9 WHEA Support
- 4.4.10 NCT6779D Super IO Configuration
- 4.4.11 Intel Server Platform Services
- 4.4.12 Onboard LAN Configuration
- 4.4.13 MIO Card Configuration
- 4.4.14 Serial Port Console Redirection
- 4.4.15 Runtime Error Logging Support
- 4.4.16 APM
- 4.4.17 Network Stack
- 4.4.18 Intel RC Drivers Version Detail
- 4.5 Event Logs menu
- 4.6 Boot menu
- 4.7 Monitor menu
- 4.8 Security
- 4.9 Tool menu
- 4.10 Exit menu
- Chapter 5: RAID configuration
- Chapter 6: Driver installation
Chapter 3: Motherboard information
3-8
2. Hard disk activity LED connector (4-pin HDLED1)
This LED connector is for the storage add-on card cable connected to the SATA or SAS
add-on card. The read or write activities of any device connected to the SATA or SAS
add-on card causes the front panel LED to light up.
3. USB 2.0 connector (10-1 pin USB78, 10-1 pin USB1011; A-Type USB9)
These connectors are for USB 2.0 ports. Connect the USB module cables to
connectors USB78. These USB connectors comply with USB 2.0 specification that
supports up to 480 Mbps connection speed.