TS100-E8-PI4 Manual
Table Of Contents
- Contents
- Chapter 1: Product introduction
- Chapter 2: Hardware setup
- Chapter 3: Motherboard Info
- 3.1 Motherboard layout
- 3.2 Jumpers
- 3.3 Internal connectors
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 CPU Configuration
- 4.4.2 PCH-IO Configuration
- 4.4.3 SATA Configuration
- 4.4.4 System Agent (SA) Configuration
- 4.4.5 PCI Subsystem Settings
- 4.4.6 USB Configuration
- 4.4.7 TPM
- 4.4.8 ACPI Settings
- 4.4.9 WHEA Support
- 4.4.10 NCT6779D Super IO Configuration
- 4.4.11 Intel Server Platform Services
- 4.4.12 Onboard LAN Configuration
- 4.4.13 MIO Card Configuration
- 4.4.14 Serial Port Console Redirection
- 4.4.15 Runtime Error Logging Support
- 4.4.16 APM
- 4.4.17 Network Stack
- 4.4.18 Intel RC Drivers Version Detail
- 4.5 Event Logs menu
- 4.6 Boot menu
- 4.7 Monitor menu
- 4.8 Security
- 4.9 Tool menu
- 4.10 Exit menu
- Chapter 5: RAID configuration
- Chapter 6: Driver installation
Chapter 2: Hardware setup
2-14
2.6 Hard disk drives (HDD)
The server system supports four (4) Serial ATA hard disk drives with plastic HDD rails.
To install a Serial ATA hard disk drive:
1. Attach the bundled plastic HDD
rails and secure it with four (4)
screws.
2. Carefully insert the HDD with the plastic
HDD rails assembly all the way into the
drive bay.
3. Connect the SATA cable to the HDD
SATA connector.
4. Connect a power plug from the power
supply to the power connector on the
back of the drive.
2
3
4