TS100-E8-PI4 Manual
Table Of Contents
- Contents
- Chapter 1: Product introduction
- Chapter 2: Hardware setup
- Chapter 3: Motherboard Info
- 3.1 Motherboard layout
- 3.2 Jumpers
- 3.3 Internal connectors
- 4.1 Managing and updating your BIOS
- 4.2 BIOS setup program
- 4.3 Main menu
- 4.4 Advanced menu
- 4.4.1 CPU Configuration
- 4.4.2 PCH-IO Configuration
- 4.4.3 SATA Configuration
- 4.4.4 System Agent (SA) Configuration
- 4.4.5 PCI Subsystem Settings
- 4.4.6 USB Configuration
- 4.4.7 TPM
- 4.4.8 ACPI Settings
- 4.4.9 WHEA Support
- 4.4.10 NCT6779D Super IO Configuration
- 4.4.11 Intel Server Platform Services
- 4.4.12 Onboard LAN Configuration
- 4.4.13 MIO Card Configuration
- 4.4.14 Serial Port Console Redirection
- 4.4.15 Runtime Error Logging Support
- 4.4.16 APM
- 4.4.17 Network Stack
- 4.4.18 Intel RC Drivers Version Detail
- 4.5 Event Logs menu
- 4.6 Boot menu
- 4.7 Monitor menu
- 4.8 Security
- 4.9 Tool menu
- 4.10 Exit menu
- Chapter 5: RAID configuration
- Chapter 6: Driver installation
Chapter 2: Hardware setup
2-2
2.1 Chassis cover
2.1.1 Removing the side cover
• Ensure that you unplug the power cord before removing the side cover.
• Take extra care when removing the side cover. Keep your fingers from components
inside the chassis that can cause injury, such as the CPU fan, rear fan, and other
sharp-edged parts.
• The images of the barebone server shown in this section are for reference purposes
only and may not exactly match the model you purchase.
2. Slide the side cover for about half
an inch toward the rear until it is
disengaged from the chassis.
3. Carefully lift the side cover and set it
aside.
1
1
2
To remove the side cover:
1. Remove the two screws that secure the
side cover.