Quick Start Guide
Reboot modem and ensure its connection is ready
Reiniciar el módem y asegurarse de que su conexión está lista
請重新啟動數據機，並確保其已準備就緒，可以進行網路連線
Notice: Unplug modem for 10 sec then plug back in
Aviso: Desenchufe el módem durante 10 segundos y vuelva a enchufarlo
注意：請拔下數據機的電源插頭 10 秒，然後再插回
Prepare your ASUS router and power it on
Prepara tu enrutador ASUS y enciéndelo
準備好您的華碩路由器並開機
Once the power LED lights up, it’s ready for setup
Una vez que la luz de estado es azul jo, está listo para la instalación
當電源指示燈亮起時，可以準備開始安裝
Support Wall Mount
IMPORTANT! DO NOT mount this equipment higher than 2 meters.
NOTE: It is recommended to use screws with a size of PA5.7*2mm.
¡IMPORTANTE! NO coloque este equipo a una altura mayor que los 2 metros.
NOTA: Se recomienda utilizar tornillos de tamaño PA5.7*2mm.
重要！ 本產品適用於安裝高度
≤
2m。
注意： 建議使用尺寸為 PA5.7*2mm 的螺絲。
[App] Scan the code and download ASUS ExpertWiFi app for setup
[App] Escanea el código y descarga la aplicación ASUS ExpertWiFi para
la instalación
[App] 掃描此 code 並下載 ASUS ExpertWiFi App 以進行網路設定
https://asus.click/asusexpertwifii https://asus.click/asusexpertwifia
ASUS ExpertWiFi
[Web] Open a web browser and navigate to http://expertwi.net for
web setup
[Web] Abra un navegador web y navegue a http://expertwi.net para la
instalación de la web.
[網頁] 開啟網頁瀏覽器並至 http://expertwifi.net 進行網頁設
定。
WALL
70mm
100mm
WALL
EBG15/EBP15
EBG15/EBP15
EBG19P
EBG19P
ASUS Recycling/Takeback Services
ASUS recycling and takeback programs come from our commitment to the highest standards for protecting our environment.
We believe in providing solutions for you to be able to responsibly recycle our products, batteries, other components, as well as
the packaging materials. Please go to http://csr.asus.com/english/Takeback.htm for the detailed recycling information in dierent
regions.
REACH
Complying with the REACH (Registration, Evaluation, Authorisation, and Restriction of Chemicals) regulatory framework, we
published the chemical substances in our products at ASUS REACH website at http://csr.asus.com/english/REACH.htm
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC RF Caution Statement
WARNING: Any changes or modications not expressly approved by the party responsible for compliance could void your
authority to operate the equipment.
FCC RF Exposure information:
This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to
exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the
U.S. Government. The exposure standard employs a unit of measurement known as the Specic Absorption Rate, or SAR. The SAR
limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted using standard operating positions accepted by the FCC with the EUT
transmitting at the specied power level in dierent channels. The FCC has granted an Equipment Authorization for this device
with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this device is on
le with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid.